RM48-S1 electronic digital tachometr with set point and alarm

UK based manufacturer of Electronic Control Equipment

A Servecon Ltd Company

WANTED UK and Worldwide Stockists and Agents : WANTED

people counters, people counting, hand held tachometers, electronic counters, digital timers, plug in timers, proximity sensors, shaft encoders, level control, large digital display, digital panel meters, signal conditioning, electronic timers, timing relays, batch counters, totalizing counters, totalising counters, dpm, sensors, photoelectric, capacitive, inductive, photoelectric, encoder, signal conversion, ratemeter, incremental encoder, decade boxes, resistance substitution box, capacitance substitution box, data display, rs485, rs232, custom electronics, system designsystem designcustom electronicsrs232rs485data displaycapacitance substitution boxresistance substitution boxdecade boxesincremental encoderratemetersignal conversionencoderphotoelectricinductivecapacitivephotoelectricsensorsdpmtotalising counterstotalizing countersbatch counterstiming relayselectronic timerssignal conditioningdigital panel meterslarge digital displaylevel controlshaft encodersproximity sensorsplug in timerselectronic countersdigital timershand held tachometerspeople countingpeople counters

[UP] [PRODUCTS][HOME]

RM48-S1 4 decade digital tachometer with setpoint (Alarm)

View Datasheet

	48 x 48 mm DIN standard Housing
	0 - 9999 RPM (ppm)
	115/230VAC 0r 12-28VDC supply
	12VDC output for proximity sensors etc
	5 Amp changeover relay output
	Over or under speed alarm
	Non Volatile Memory of setpoint
	NPN or PNP type inputs
	Factory set input prescaler
	Panel or plug in mounting

Mode of Operation: This ratemeter is programmed using the panel touch switches to set the alarm value. This value is stored in the non-volatile memory and is retained when power is removed.

Overspeed Mode: The relay is energised at and above the setpoint for overspeed mode

UnderThe relay is energised at and below the setpoint for overspeed mode

Specification

Inputs:	Pulse, PNP/NPN select
Signal input:	PNP or NPN source such as DC proximity switch
Indication:	Pulses on input - Flashing LED
	Over range - Leading digit shows 8 others blank
	Relay energised - LED illuminated
Relay output:	Single pole changeover contacts - 5 amp at 240VAC or 30VDC
DC Output:	12 VDC @ 50 ma for powering sensors
Supply:	115/240 VAC or 12 - 30 VDC (specify when ordering)
Housing:	48mm x 48 mm DIN standard panel mounting plastic
Dimensions:	48 x 48 x 135 mm
Panel Cutout:	45 x 45 mm
Connections:	11 pin standard plug in base.
Order code	RM48-S1 or RM48-S1-DC

[UP] [PRODUCTS][HOME]


	Visa, Mastercard and Debit cards accepted