Detect failure of rotating or
reciprocating machines
Proximity sensor or switch input
Wide selection of time ranges
48 x 48 mm DIN panel mounting or plug in
case
8 Amp single pole relay output
Voltages from 12-35 VDC & 115 and
240 VAC
12VDC output for powering sensors
Standard 11 pin plug in base
Mode of Operation:The
ZM3 controller is designed to monitor rotating machinery and to give an alarm
output (relay changing state) when the speed of the machine drops below the set
value. When powered up the internal relay energises and the time period starts.
An input signal, usually from a proximity sensor, is generated as the machine
rotates. If the time interval between pulses exceeds the time set on the ZM3
then the relay will de-energise.
Any subsequent input pulses will reset the ZM3
and restart the time period. If the automatic resetting of the ZM3 is unwanted
then a latching version is available that will only be reset by removing the
power supply.
Specification
Relay output:
Single pole changeover contacts - 8 amp at 240VAC or 30VDC
Supply:
115/240 VAC or 12 - 35 VDC
Input Signal:
PNP type (1000 ohms to 0v) Maximum
input voltage of 35v
DC output
12VDC @ 50mA for powering sensors
Input Pulse Rate:
5000 pulses per second maximum
Housing:
48mm x 48 mm DIN standard panel mounting
or plug in plastic
