Portable Battery powered Stroboscope - Model DT-725

General Description A general purpose competitively priced light weight portable Strobe designed for continuous operation over a generous frequency range. The DT-725 Stroboscope has several application specific features, including digital flash control, flash rate multiplier, phase shift for slow motion observation, slave control, accurate frequency control, it has a permanently fitted pistol grip for easy torch like use. The instrument is battery powered from an internal rechargeable battery and a suitable 230vc charger is supplied. This light weight Stroboscope is ideal for general purpose use, for example, non-contact speed checking, machine motion monitoring, fault diagnosis and location of faulty operations on packaging & bottling machinery and Condition Monitoring requirements and machine Balancing. The DT-725 can be externally triggered or it can trigger external equipment, such as Balancing systems, as standard and the integral digitised frequency control provides precise manual setting of flash rate and yet gives very rapid response to changes in rate over the whole frequency range. Key features · Digital Display of flash rate or phase · Continuously rated · Phase shift mode for slow motion monitoring · Light weight - Torch style housing · Internal Battery powered · Internal/external triggering · Synch. Pulse output · High flash power for size · Tripod mountable

General Specification Display Flash Energy Flash Tube Freq. Rate Flash Duration Res. Accuracy Rate Multiplier Ext. Triggering Synch. Output Phase Shift Resolution Phase Control Controls Memory Power Input Temp. cut-out Housing Battery Type Standard Pack - 5 Digit red 10mm LED display - 10w - Xenon type (100m flashes) - Overall 40 - 12,500 - 10-15 microsecs - Range 1. - 0.1 digit - Range 2. - 0.2 digit - Range 3. - 0.5 digit - Range 4. - 1.0 digit - +/- 0.02% - x 2 & x ½ features via pushbuttons - 2 wire Pulse input between 12-24vdc via 3.5mm jack - Standard via 3.5mm jack socket - plug supplied - Fully adjustable between 0-360° - 0.1° - Digital in 0.1° steps - 1. Two position Range switch - 2 Digitiser frequency control - 3. Push switch for freq/Phase selection - Control setting retained on power down - 12/24vdc @ 3.5A max. Smoothed and Regulated via 230vac power adaptor supplied - Integral temperature cut- out for overheat protection - Brown ABS - tripod bush in base - Sealed lead/acid 12v gel type - 230vac Charger UK 13A type

Additional Information Signal Output The DT-725 Strobe is an ideal low cost accurate diagnostic tool ideal for location of machine faults due to wear & shaft balancing situations on most rotating and reciprocating machinery. Synch. Pulse output facility is standard.